Bloomfield 1016BVM Dokumentacja Pobierz pdf (Strona 22)

CAUTION -

CHEMICAL BURN

HAZARD

Deliming chemicals are caustic.

Wear appropriate protective

gloves and goggles during this

procedure.

Never siphon deliming

chemicals or solutions by

mouth.

This operation should only be

performed by qualied and

experienced service personnel.

IMPORTANT:

DO NOT spill, splash or pour

water or deliming solution into

or over any internal component

other than the inside of the

water tank.

IMPORTANT:

DO NOT allow any internal

components to come into

contact with the deliming

solution. Take care to keep all

internal components dry.

NOTE: Repeat steps 4 thru 5

as required to remove all scale

and lime build-up.

NOTE: Normally, silicone hoses

do not need to be delimed.

Should deliming hoses become

necessary, Bloomeld recom-

mends replacing the hoses.

PROCEDURE: Delime the Water Tank

PRECAUTIONS: Disconnect brewer from electric power.

Allow brewer to cool.

FREQUENCY: As required (Brewer slow to heat)

TOOLS: Deliming Solution

Protective Gloves, Goggles & Apron

Mild Detergent, Clean Soft Cloth or Sponge

Bristle Brush, Bottle Brush

Large Sink (or other appropriate work area)

Unplug power cord. Turn off the water shut-off valve and

disconnect the water supply line from the brewer inlet tting

Remove the tank lid assembly as described on page 16.

Remove the water tank from the brewer body by lifting

straight up. Empty all water from the tank. Set the tank back

into the brewer.

Mix 2 quarts of deliming solution according to the

manufacturer’s directions. Carefully pour the deliming

solution into the water tank. Lower the lid assembly back

onto the tank. Allow to sit for 30 minutes, or as directed by

the manufacturer.

At end of soaking period, remove lid assembly from tank.

Thoroughly rinse internal components of lid assembly with

clear water. Using a stiff bristle brush, scrub the heating

element and faucet water coil to remove lime and calcium

build-up. Rinse with clean water. Store lid assembly in a safe

location.

Remove the tank from the brewer and empty. Using a stiff

bristle brush, scrub the interior of the water tank to remove

lime and calcium build-up. Rinse with clean water.

Set the tank back into the brewer. Reassemble the tank lid to

the water tank. Make sure the gasket is properly in place,

then reinstall lid clamps.

Reinstall wiring to heating element and thermostat. Reas-

semble piping for the faucet. Verify that all internal

components are dry, then reinstall the top panel.

Reconnect brewer to electrical supply and reconnect water

supply.

Install the brew chamber without lter paper or grounds.

Run at least three full brew cycles and discard all water

generated.

Brewer is ready to use.

10.

11.

SERVICING INSTRUCTIONS (continued)

912 p/n 2M-75936 Owners Manual 1016BVM Coffee Brewer

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

Bloomfield 1016BVM Dokumentacja Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekspresy do kawy Bloomfield 1016BVM